Referenced sub-routine 'probe_midpoint.ngc' is missing in repo

[fettboy]

Hello,
I installed easyProbe and I like it - thank you for your good work.
I found two issues
A.)
When doing a midpoint-measurement, the software tries to call the subroutine 'probe_midpoint' which is not part of the repository (ls -R | grep "probe_midpoint" ).
The subroutine 'probe_midpoint' is called in probe_pocket.ngc in line 256.
Could you please provide the file probe_midpoint.ngc

B.)
All the button in the side-panel are attached to their commands and work fine - with one exception: the last button "calibration" is not attached to o<probe_calibration> call. So unfortuantely I only can do a calibration via the MDI. I checked your source-files there are unchanged and the Probe_postgui.hal contains 'net pyvcp-probe-calibration pyvcp.probe_calib => halui.mdi-command-26' as the last mdi-command.
What could went wrong here?

Thanks in advance!

[hausen8]

Thanks for the information. probe_midpoint.ngc is missing indeed. We will add the file soon.

Regarding the probe_calibration problem I have no idea so far. The buttons calls probe_calibration.ngc via MDI_COMMAND 26 and the file is available. Do you get any error message?

[juliankoenig87]

Hello, I installed easyProbe and I like it - thank you for your good work. I found two issues A.) When doing a midpoint-measurement, the software tries to call the subroutine 'probe_midpoint' which is not part of the repository (ls -R | grep "probe_midpoint" ). The subroutine 'probe_midpoint' is called in probe_pocket.ngc in line 256. Could you please provide the file probe_midpoint.ngc

B.) All the button in the side-panel are attached to their commands and work fine - with one exception: the last button "calibration" is not attached to o<probe_calibration> call. So unfortuantely I only can do a calibration via the MDI. I checked your source-files there are unchanged and the Probe_postgui.hal contains 'net pyvcp-probe-calibration pyvcp.probe_calib => halui.mdi-command-26' as the last mdi-command. What could went wrong here?

Thanks in advance!

Hi. You found a work in progress part at a).

Work around is:

Probe the pocket without the midpoint mode oder the rotation mode teiggered before. Then activate the midpoint or rotation mode and press the mode again! Then the current set zero point (probed before) will set as the first probe. Then do the second probe.

Should make a hint message at this situation.

To B) I have no clue. This normally should work.
Best regards Julian

[fettboy]

Thanks for your replies. to A.) Yes, I use the workaround already. It would be great if, if you could upload the missing probe_midpoint.ngc soon, so that users of the machine are not confused by the error-messages any more. Thanks in advance!
to B) Solved :-), Was a typo on my side ( Cal --> Call ).